# Gandy Warm Springs, Utah

Gandy Warm Springs in Utah. 81°F (27°C). Short Walk · Public Land. White Pine County.

- Page: https://www.soakingsprings.com/hot-springs/utah/gandy-warm-springs
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at Gandy Warm Springs?

The water leaves the ground at 81°F, about as warm as a heated pool. It's a short walk from the road. It's on Bureau of Land Management land. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 81°F (27°C) (USGS record; developed pools are often cooled) |
| pH | 7.5 (Slightly Alkaline) |
| Total dissolved solids | 297 mg/L |
| Elevation | 5,237 ft |
| Access | Short Walk · Public Land, 0.2 mi from the nearest road |
| Land | Fillmore Field Office, Bureau of Land Management |
| County | White Pine County |
| Nearest town | McGill |
| Coordinates | 39.46400, -114.03800 |
| Best months to soak | January, December, February (largest gap between water and average air temperature) |

## About Gandy Warm Springs

Gandy Warm Springs is an open-access spring on BLM ground administered from Fillmore, filed under White Pine County with McGill given as the closest town at zero miles. The water is warm and notably fresh, with dissolved solids low enough to count as good water by desert standards. It is below soaking heat.

A walk of around a fifth of a mile from an unnamed road. Elevation is a little over five thousand feet, dry basin country with a couple feet of snow most winters and under ten inches of precipitation. No campground is named in the record. The Fillmore Field Office is the managing unit.

Winter is listed as best. No fee shows up, and access is open. Water analysis dates to 2005, and it shows very low dissolved solids. Nothing on file describes the spring itself, so go ready for anything. McGill is the town the record gives.

## Water chemistry

Lab sample from 2005-11-08 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 7.5 |
| Total dissolved solids | 297 mg/L |
| Calcium | 47.3 mg/L |
| Magnesium | 17 mg/L |
| Sodium | 28.5 mg/L |
| Sulfate | 22.5 mg/L |
| Chloride | 22.8 mg/L |

## Nearby

- Nearest city page: [Hot springs near Milford](https://www.soakingsprings.com/hot-springs/near/utah/milford), 79 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [Unnamed thermal spring, UT](https://www.soakingsprings.com/hot-springs/utah/unnamed-spring-white-pine-county): 68°F source, Roadside, near McGill, White Pine County
- [Twin Springs, UT](https://www.soakingsprings.com/hot-springs/utah/twin-springs-2): 68°F source, pH 7.7, Roadside, near McGill, White Pine County
- [Knoll Springs, UT](https://www.soakingsprings.com/hot-springs/utah/knoll-springs): 68°F source, pH 7.7, Short Walk, near McGill, White Pine County
- [Unnamed thermal spring, UT](https://www.soakingsprings.com/hot-springs/utah/unnamed-spring-millard-county-2): 77°F source, Short Walk, near Delta, Millard County
- [Tule Spring, UT](https://www.soakingsprings.com/hot-springs/utah/tule-spring): 82°F source, pH 7.7, Roadside, near Delta, Millard County
- [South Tule Spring, UT](https://www.soakingsprings.com/hot-springs/utah/south-tule-spring): 77°F source, Short Walk, near Delta, Millard County

## Questions

**What is the water temperature at Gandy Warm Springs?**
Gandy Warm Springs has a water temperature of 81°F (27°C). This is a warm thermal spring.

**Where is Gandy Warm Springs located?**
Gandy Warm Springs is located in White Pine County, Utah at 5,237 feet elevation, near McGill. Coordinates: 39.4640°N, 114.0380°W.

**How do I get to Gandy Warm Springs?**
Gandy Warm Springs has Short Walk road access (0.2 mi from the road).

**Is Gandy Warm Springs free to visit?**
Gandy Warm Springs has Open access. It is managed by Bureau of Land Management.

**What minerals are in the water at Gandy Warm Springs?**
Water chemistry analysis shows the presence of pH, Total Dissolved Solids, Calcium, Magnesium, Sodium, Sulfate, Chloride. The pH is 7.5 (slightly alkaline). Total dissolved solids measure 297 mg/L.

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals