# Hatton Hot Spring, Utah

Hatton Hot Spring in Utah. 100°F (38°C). Roadside. Millard County.

- Page: https://www.soakingsprings.com/hot-springs/utah/hatton-hot-spring
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at Hatton Hot Spring?

The water leaves the ground at 100°F, a comfortable soaking temperature. You can drive right up to it. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 100°F (38°C) (USGS record; developed pools are often cooled) |
| pH | 7.1 (Neutral) |
| Elevation | 4,840 ft |
| Access | Roadside, 135 ft from the nearest road |
| County | Millard County |
| Nearest town | Fillmore |
| Coordinates | 38.85000, -112.49000 |
| Best months to soak | January, December, February (largest gap between water and average air temperature) |
| Nearest campground | ADELAIDE CAMPGROUND, 9.2 mi |

## About Hatton Hot Spring

Hatton Hot Spring comes out of the ground at a temperature you could sit in, a touch over body heat, in Millard County's valley country about eleven miles from Fillmore. It is a USGS-listed thermal spring with no resort and no named operator on file. Whose land it sits on has never been recorded, so treat that as an open question before you go.

Access is about as easy as it gets on paper. The spring sits a stone's throw from a road, under 150 feet, and the road itself has no name in the record. At roughly 4,800 feet this is valley floor with dry summers and a winter that brings a fair amount of snow, enough that a December visit can mean plowed roads or worse. Public or private land, the record does not say.

The record favors the dead of winter, December through February, which lines up with soaking-warm water and cold air. Adelaide Campground is about nine miles off. The water chemistry on file dates to a 1985 survey, so expect the temperature and flow to have drifted. With no access status recorded, ask locally or check county parcel maps before walking in.

## Water chemistry

Lab sample from 1985-10-25 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 7.1 |
| Calcium | 420 mg/L |
| Magnesium | 89 mg/L |
| Sodium | 890 mg/L |
| Sulfate | 940 mg/L |
| Chloride | 1,700 mg/L |
| Iron | 520 µg/L |

## Nearby

- Nearest city page: [Hot springs near Fillmore](https://www.soakingsprings.com/hot-springs/near/utah/fillmore), 0 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [Meadow Hot Springs, UT](https://www.soakingsprings.com/hot-springs/utah/meadow-hot-springs): 106°F source, pH 6.9, TDS 5,120 mg/L, Roadside, near Fillmore, Millard County
- [Unnamed thermal spring, UT](https://www.soakingsprings.com/hot-springs/utah/unnamed-spring-millard-county-3): 72°F source, pH 6.8, TDS 5,000 mg/L, Roadside, near Fillmore, Millard County
- [Sulphurdale, UT](https://www.soakingsprings.com/hot-springs/utah/sulphurdale): 72°F source, Short Walk, near Beaver, Beaver County
- [Coyote Spring, UT](https://www.soakingsprings.com/hot-springs/utah/coyote-spring-2): 68°F source, pH 7.5, TDS 558 mg/L, Short Walk, near Milford, Beaver County
- [Springs, UT](https://www.soakingsprings.com/hot-springs/utah/springs-beaver-county): 68°F source, pH 7.5, TDS 558 mg/L, Short Walk, near Milford, Beaver County
- [Richfield Warm Springs, UT](https://www.soakingsprings.com/hot-springs/utah/richfield-warm-springs): 73°F source, Roadside, near Richfield, Sevier County

## Questions

**What is the water temperature at Hatton Hot Spring?**
Hatton Hot Spring has a water temperature of 100°F (38°C). This is considered a hot spring, well above body temperature.

**Where is Hatton Hot Spring located?**
Hatton Hot Spring is located in Millard County, Utah at 4,840 feet elevation, near Fillmore. Coordinates: 38.8500°N, 112.4900°W.

**How do I get to Hatton Hot Spring?**
Hatton Hot Spring has Roadside road access (135 ft from the road).

**Can I camp near Hatton Hot Spring?**
Yes, Adelaide Campground is located nearby (9.2 miles away).

**What minerals are in the water at Hatton Hot Spring?**
Water chemistry analysis shows the presence of pH, Calcium, Magnesium, Sodium, Sulfate, Chloride, Iron. The pH is 7.1 (neutral).

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals