# Larson Springs, Utah

Larson Springs in Utah. 70°F (21°C). Short Walk. Cassia County.

- Page: https://www.soakingsprings.com/hot-springs/utah/larson-springs
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at Larson Springs?

The water leaves the ground at 70°F, about as warm as a heated pool. It's a short walk from the road. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 70°F (21°C) (USGS record; developed pools are often cooled) |
| pH | 8.0 (Slightly Alkaline) |
| Total dissolved solids | 795 mg/L |
| Elevation | 5,540 ft |
| Access | Short Walk, 341 ft from the nearest road (17600 North) |
| County | Cassia County |
| Nearest town | Burley |
| Coordinates | 41.81800, -113.31100 |
| Best months to soak | January, December, February (largest gap between water and average air temperature) |
| Nearest campground | Clear Creek Campground, 9.3 mi |

## About Larson Springs

Larson Springs is another of the Cassia County warm springs near Burley that USGS catalogued in the mid 1960s, this one roughly eighteen miles from town. Its water is tepid, about the temperature of a swimming pool in late summer. No one has recorded an owner, an access rule, or a fee.

17600 North is the road, and the spring sits a few hundred feet off it, so the walking part is brief once you spot the right turn. Elevation runs a little over 5,500 feet. The climate leans dry and a winter will bring somewhere around two feet of snow. There is no named land unit here and no designation attached.

Winter is the listed season. Clear Creek Campground is the nearest camping on record, a little over nine miles off. The mineral reading on file is from 1966 and nothing newer exists; it showed fairly mineral water. Access is unknown, so check it.

## Water chemistry

Lab sample from 1966-06-17 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 8 |
| Total dissolved solids | 795 mg/L |
| Calcium | 44 mg/L |
| Magnesium | 10 mg/L |
| Sodium | 250 mg/L |
| Sulfate | 39 mg/L |
| Chloride | 125 mg/L |

## Nearby

- Nearest city page: [Hot springs near Brigham City](https://www.soakingsprings.com/hot-springs/near/utah/brigham-city), 69 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [W.R. Carter Springs, UT](https://www.soakingsprings.com/hot-springs/utah/w-r-carter-springs): 70°F source, pH 8.1, TDS 292 mg/L, Short Walk, near Burley, Cassia County
- [L.G. Carter Springs, UT](https://www.soakingsprings.com/hot-springs/utah/l-g-carter-springs): 77°F source, pH 8.0, TDS 274 mg/L, Short Walk, near Burley, Cassia County
- [Pugsley, UT](https://www.soakingsprings.com/hot-springs/utah/pugsley): 73°F source, pH 7.2, TDS 314 mg/L, Short Walk, near Burley, Cassia County
- [Warm Spring, UT](https://www.soakingsprings.com/hot-springs/utah/warm-spring-cassia-county-2): 81°F source, pH 8.5, TDS 223 mg/L, Short Walk, near Burley, Cassia County
- [Coyote Spring, UT](https://www.soakingsprings.com/hot-springs/utah/coyote-spring-4): 109°F source, pH 7.6, TDS 3,240 mg/L, Roadside, near Malad City, Oneida County
- [Head Spring, UT](https://www.soakingsprings.com/hot-springs/utah/head-spring): 70°F source, pH 8.0, TDS 240 mg/L, Roadside, near Burley, Cassia County

## Questions

**What is the water temperature at Larson Springs?**
Larson Springs has a water temperature of 70°F (21°C). This is a warm thermal spring.

**Where is Larson Springs located?**
Larson Springs is located in Cassia County, Utah at 5,540 feet elevation, near Burley. Coordinates: 41.8180°N, 113.3110°W.

**How do I get to Larson Springs?**
Larson Springs has Short Walk road access, with the nearest road being 17600 North (341 ft from the road).

**Can I camp near Larson Springs?**
Yes, Clear Creek Campground is located nearby (9.3 miles away).

**What minerals are in the water at Larson Springs?**
Water chemistry analysis shows the presence of pH, Total Dissolved Solids, Calcium, Magnesium, Sodium, Sulfate, Chloride. The pH is 8.0 (slightly alkaline). Total dissolved solids measure 795 mg/L.

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals