# Midway Hot Springs, Utah

Midway Hot Springs in Utah. 104°F (40°C). Roadside. Wasatch County.

- Page: https://www.soakingsprings.com/hot-springs/utah/midway-hot-springs-1
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at Midway Hot Springs?

The water leaves the ground at 104°F, a comfortable soaking temperature. You can drive right up to it. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 104°F (40°C) (USGS record; developed pools are often cooled) |
| pH | 7.3 (Slightly Alkaline) |
| Total dissolved solids | 1,730 mg/L |
| Elevation | 5,650 ft |
| Access | Roadside, 289 ft from the nearest road (Mountain Spa Lane) |
| County | Wasatch County |
| Nearest town | Midway |
| Coordinates | 40.52500, -111.46800 |
| Best months to soak | December, January, February (largest gap between water and average air temperature) |
| Nearest campground | ALBION BASIN, 8.3 mi |

## About Midway Hot Springs

Half a mile or so outside Midway in Wasatch County, this Midway Hot Springs point comes up at a true soaking temperature, right around the heat of a hot tub. Mountain Spa Lane is the nearest road on record. Public or private, the record does not say. USGS sampled the water in the 1960s.

The spring is a few hundred feet from Mountain Spa Lane at around 5,600 feet in a mountain valley. Snowfall here is heavy, the record shows over a hundred inches a year, and the climate is wet for Utah, with a cool annual average. Land ownership and unit are blank.

December, January, February: the months on record. Albion Basin is the nearest campground listed, eight miles distant. The chemistry on file, with a middling mineral load, comes from 1966 and has not been re-measured. There is no fee noted and no access status recorded, so ask before you go.

## Water chemistry

Lab sample from 1966-09-28 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 7.3 |
| Total dissolved solids | 1,730 mg/L |
| Calcium | 331 mg/L |
| Magnesium | 68 mg/L |
| Sodium | 114 mg/L |
| Sulfate | 661 mg/L |
| Chloride | 108 mg/L |

## Nearby

- Nearest city page: [Hot springs near Midway](https://www.soakingsprings.com/hot-springs/near/utah/midway), 1 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [Midway Hot Spring, UT](https://www.soakingsprings.com/hot-springs/utah/midway-hot-spring): 115°F source, pH 7.3, TDS 1,730 mg/L, Roadside, near Midway, Wasatch County
- [Warm Ditch Spring, UT](https://www.soakingsprings.com/hot-springs/utah/warm-ditch-spring): 115°F source, Roadside, near Midway, Wasatch County
- [Midway Hot Springs, UT](https://www.soakingsprings.com/hot-springs/utah/midway-hot-springs-2): 100°F source, Roadside, near Midway, Wasatch County
- [Unnamed thermal spring, UT](https://www.soakingsprings.com/hot-springs/utah/unnamed-spring-summit-county): 70°F source, Short Walk, near Snyderville, Summit County
- [Crystal Hot Springs, UT](https://www.soakingsprings.com/hot-springs/utah/crystal-hot-springs): 187°F source, pH 7.2, Short Walk, near Bluffdale, Salt Lake County
- [East Jordan Canal, UT](https://www.soakingsprings.com/hot-springs/utah/east-jordan-canal): 73°F source, Roadside, near South Jordan, Salt Lake County

## Questions

**What is the water temperature at Midway Hot Springs?**
Midway Hot Springs has a water temperature of 104°F (40°C). This is considered a hot spring, well above body temperature.

**Where is Midway Hot Springs located?**
Midway Hot Springs is located in Wasatch County, Utah at 5,650 feet elevation, near Midway. Coordinates: 40.5250°N, 111.4680°W.

**How do I get to Midway Hot Springs?**
Midway Hot Springs has Roadside road access, with the nearest road being Mountain Spa Lane (289 ft from the road).

**Can I camp near Midway Hot Springs?**
Yes, Albion Basin is located nearby (8.3 miles away).

**What minerals are in the water at Midway Hot Springs?**
Water chemistry analysis shows the presence of pH, Total Dissolved Solids, Calcium, Magnesium, Sodium, Sulfate, Chloride. The pH is 7.3 (slightly alkaline). Total dissolved solids measure 1,730 mg/L.

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals