# North Springs, Utah

North Springs in Utah. 82°F (28°C). Roadside · Public Land. Millard County.

- Page: https://www.soakingsprings.com/hot-springs/utah/north-springs
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at North Springs?

The water leaves the ground at 82°F, about as warm as a heated pool. Access is restricted. You can drive right up to it. It's on US Fish and Wildlife Service land. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 82°F (28°C) (USGS record; developed pools are often cooled) |
| pH | 7.9 (Slightly Alkaline) |
| Total dissolved solids | 2,910 mg/L |
| Elevation | 4,303 ft |
| Access | Roadside · Public Land, 15 ft from the nearest road |
| Land | Fish Springs National Wildlife Refuge, US Fish and Wildlife Service |
| County | Millard County |
| Nearest town | Delta |
| Coordinates | 39.88700, -113.41300 |
| Best months to soak | January, December, February (largest gap between water and average air temperature) |

## About North Springs

Inside Fish Springs National Wildlife Refuge, in Millard County, Utah, North Springs is one of several. Nothing is nearby. Delta, the closest town anyone recorded, sits almost sixty miles off. The water comes out warm, about what a tepid bath feels like. Access is restricted, and the ground is a National Wildlife Refuge held by the federal Fish and Wildlife Service.

The spring is almost on top of the road, fifteen feet off, inside the refuge. This is low desert, a bit over 4,300 feet, and very dry: around seven inches of rain a year and little snow. The refuge is federal land with a wildlife designation, so the rules are the refuge's rules.

Restricted access is the headline. Do not plan on soaking; plan on checking with the refuge before you go and following what they allow. Winter months are the best listed, and the dry climate makes that a reasonable window for the drive. No campground is on file. The water is mineral-heavy, sampled in 1990 with iron present.

## Water chemistry

Lab sample from 1990-05-10 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 7.9 |
| Total dissolved solids | 2,910 mg/L |
| Calcium | 120 mg/L |
| Magnesium | 72 mg/L |
| Sodium | 850 mg/L |
| Sulfate | 370 mg/L |
| Chloride | 1,300 mg/L |
| Iron | 20 µg/L |

## Nearby

- Nearest city page: [Hot springs near Tooele](https://www.soakingsprings.com/hot-springs/near/utah/tooele), 56 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [Wilson Health Springs, UT](https://www.soakingsprings.com/hot-springs/utah/wilson-health-springs): 142°F source, Short Walk, near Delta, Millard County
- [Fish Springs, UT](https://www.soakingsprings.com/hot-springs/utah/fish-springs-4): 82°F source, pH 8.2, TDS 1,800 mg/L, Roadside, near Delta, Millard County
- [Coyote Spring, UT](https://www.soakingsprings.com/hot-springs/utah/coyote-spring-3): 82°F source, pH 7.1, Short Walk, near Delta, Millard County
- [Unnamed thermal spring, UT](https://www.soakingsprings.com/hot-springs/utah/unnamed-spring-millard-county-2): 77°F source, Short Walk, near Delta, Millard County
- [Fumarole Butte, UT](https://www.soakingsprings.com/hot-springs/utah/fumarole-butte): 73°F source, Roadside, near Delta, Millard County
- [Tule Spring, UT](https://www.soakingsprings.com/hot-springs/utah/tule-spring): 82°F source, pH 7.7, Roadside, near Delta, Millard County

## Questions

**What is the water temperature at North Springs?**
North Springs has a water temperature of 82°F (28°C). This is a warm thermal spring.

**Where is North Springs located?**
North Springs is located in Millard County, Utah at 4,303 feet elevation, near Delta. Coordinates: 39.8870°N, 113.4130°W.

**How do I get to North Springs?**
North Springs has Roadside road access (15 ft from the road).

**Is North Springs free to visit?**
North Springs has Restricted access. It is managed by US Fish and Wildlife Service.

**What minerals are in the water at North Springs?**
Water chemistry analysis shows the presence of pH, Total Dissolved Solids, Calcium, Magnesium, Sodium, Sulfate, Chloride, Iron. The pH is 7.9 (slightly alkaline). Total dissolved solids measure 2,910 mg/L.

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals