# Roosevelt Hot Springs, Utah

Roosevelt Hot Springs in Utah. 133°F (56°C). Roadside. Beaver County.

- Page: https://www.soakingsprings.com/hot-springs/utah/roosevelt-hot-springs
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at Roosevelt Hot Springs?

Only once it cools. The water leaves the ground at 133°F, hotter than any hot tub. You can drive right up to it. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 133°F (56°C) (USGS record; developed pools are often cooled) |
| pH | 7.7 (Slightly Alkaline) |
| Elevation | 6,100 ft |
| Access | Roadside, 125 ft from the nearest road |
| County | Beaver County |
| Nearest town | Milford |
| Coordinates | 38.50300, -112.84900 |
| Best months to soak | January, December, February (largest gap between water and average air temperature) |
| Nearest campground | Hanging Rock Campground, 20.0 mi |

## About Roosevelt Hot Springs

Roosevelt Hot Springs is a hot source in Beaver County, roughly a dozen miles out of Milford. Hot here means hot, well above anything you would put a hand in for long, so this is a thing to see and not a pool to enter. No owner and no public access status appear on file. The only chemistry is a pH reading and a chloride number from a sample taken in 1955.

A road comes within a couple hundred feet of it, though which road is not specified, and at that distance there is hardly any walking involved. You are at about six thousand feet in dry country, thirteen inches of moisture in a year, and winters put down around four feet of snow. Nothing on file says what land unit this is in or who manages it. A photograph is attached to the record.

The best months listed are the winter ones, December to February. The water is hot enough to burn skin, so keep your distance from the outflow and keep dogs back. Hanging Rock Campground is about twenty miles away and is the only camping listed. Access is not on record, and the one water sample is seventy years old, so verify both before you drive out.

## Water chemistry

Lab sample from 1955-11-08 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 7.7 |
| Chloride | 3,200 mg/L |

## Nearby

- Nearest city page: [Hot springs near Milford](https://www.soakingsprings.com/hot-springs/near/utah/milford), 18 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [Sulphurdale, UT](https://www.soakingsprings.com/hot-springs/utah/sulphurdale): 72°F source, Short Walk, near Beaver, Beaver County
- [Springs, UT](https://www.soakingsprings.com/hot-springs/utah/springs-beaver-county): 68°F source, pH 7.5, TDS 558 mg/L, Short Walk, near Milford, Beaver County
- [Coyote Spring, UT](https://www.soakingsprings.com/hot-springs/utah/coyote-spring-2): 68°F source, pH 7.5, TDS 558 mg/L, Short Walk, near Milford, Beaver County
- [Dotsons (Radium) Warm Spring, UT](https://www.soakingsprings.com/hot-springs/utah/dotsons-radium-warm-spring): 91°F source, pH 7.4, TDS 1,020 mg/L, Roadside, near Milford, Beaver County
- [Us Blm, UT](https://www.soakingsprings.com/hot-springs/utah/us-blm): 91°F source, pH 8.3, TDS 475 mg/L, Short Walk, near Milford, Beaver County
- [Woodhouse Spring, UT](https://www.soakingsprings.com/hot-springs/utah/woodhouse-spring): 72°F source, pH 7.7, TDS 720 mg/L, Short Walk, near Milford, Beaver County

## Questions

**What is the water temperature at Roosevelt Hot Springs?**
Roosevelt Hot Springs has a water temperature of 133°F (56°C). This is considered a hot spring, well above body temperature.

**Where is Roosevelt Hot Springs located?**
Roosevelt Hot Springs is located in Beaver County, Utah at 6,100 feet elevation, near Milford. Coordinates: 38.5030°N, 112.8490°W.

**How do I get to Roosevelt Hot Springs?**
Roosevelt Hot Springs has Roadside road access (125 ft from the road).

**Can I camp near Roosevelt Hot Springs?**
Yes, Hanging Rock Campground is located nearby (20.0 miles away).

**What minerals are in the water at Roosevelt Hot Springs?**
Water chemistry analysis shows the presence of pH, Chloride. The pH is 7.7 (slightly alkaline).

**Is it safe to soak at Roosevelt Hot Springs?**
With care. At 133°F Roosevelt Hot Springs is hot enough to need short sessions, fifteen to twenty minutes, and plenty of water. Enter slowly and get out if you feel light-headed.

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals