# Twin Springs, Utah

Twin Springs in Utah. 68°F (20°C). Roadside · Public Land. White Pine County.

- Page: https://www.soakingsprings.com/hot-springs/utah/twin-springs-2
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at Twin Springs?

The water leaves the ground at 68°F, cooler than most swimming pools. You can drive right up to it. It's on Bureau of Land Management land. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 68°F (20°C) (USGS record; developed pools are often cooled) |
| pH | 7.7 (Slightly Alkaline) |
| Elevation | 4,818 ft |
| Access | Roadside · Public Land, 115 ft from the nearest road |
| Land | Fillmore Field Office, Bureau of Land Management |
| County | White Pine County |
| Nearest town | McGill |
| Coordinates | 39.40300, -113.86300 |
| Best months to soak | January, December, February (largest gap between water and average air temperature) |

## About Twin Springs

Twin Springs is a pair of barely warm springs on Bureau of Land Management ground in White Pine County, about ten miles from McGill. Public access is listed as open, the land unit is the Fillmore Field Office, and the designation is public land. The water is in the high sixties, below what you would want for a bath. A 1983 sample found calcium and sodium along with sulfate and chloride.

A road passes within a little over a hundred feet, making this a roadside stop, though the road goes unnamed. Elevation is a bit under five thousand feet in some of the driest country in the set, about six inches of moisture a year and a foot and a half of snow. No campground is listed within range. BLM land means no gate to worry about.

Winter is the season on file, though in country this dry the road should be passable most of the year. Access is open and roadside. There is no campground on record near here. The chemistry is from 1983 and the temperature reading should be treated as old. Bring your own water, since this is arid BLM desert.

## Water chemistry

Lab sample from 1983-12-15 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 7.7 |
| Calcium | 64 mg/L |
| Magnesium | 29 mg/L |
| Sodium | 57 mg/L |
| Sulfate | 80 mg/L |
| Chloride | 66 mg/L |

## Nearby

- Nearest city page: [Hot springs near Milford](https://www.soakingsprings.com/hot-springs/near/utah/milford), 69 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [Unnamed thermal spring, UT](https://www.soakingsprings.com/hot-springs/utah/unnamed-spring-white-pine-county): 68°F source, Roadside, near McGill, White Pine County
- [Gandy Warm Springs, UT](https://www.soakingsprings.com/hot-springs/utah/gandy-warm-springs): 81°F source, pH 7.5, TDS 297 mg/L, Short Walk, near McGill, White Pine County
- [Knoll Springs, UT](https://www.soakingsprings.com/hot-springs/utah/knoll-springs): 68°F source, pH 7.7, Short Walk, near McGill, White Pine County
- [Tule Spring, UT](https://www.soakingsprings.com/hot-springs/utah/tule-spring): 82°F source, pH 7.7, Roadside, near Delta, Millard County
- [South Tule Spring, UT](https://www.soakingsprings.com/hot-springs/utah/south-tule-spring): 77°F source, Short Walk, near Delta, Millard County
- [Unnamed thermal spring, UT](https://www.soakingsprings.com/hot-springs/utah/unnamed-spring-millard-county-2): 77°F source, Short Walk, near Delta, Millard County

## Questions

**What is the water temperature at Twin Springs?**
Twin Springs has a water temperature of 68°F (20°C). This is a warm thermal spring.

**Where is Twin Springs located?**
Twin Springs is located in White Pine County, Utah at 4,818 feet elevation, near McGill. Coordinates: 39.4030°N, 113.8630°W.

**How do I get to Twin Springs?**
Twin Springs has Roadside road access (115 ft from the road).

**Is Twin Springs free to visit?**
Twin Springs has Open access. It is managed by Bureau of Land Management.

**What minerals are in the water at Twin Springs?**
Water chemistry analysis shows the presence of pH, Calcium, Magnesium, Sodium, Sulfate, Chloride. The pH is 7.7 (slightly alkaline).

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals