# Warm Spring, Utah

Warm Spring in Utah. 75°F (24°C). Roadside. Washington County.

- Page: https://www.soakingsprings.com/hot-springs/utah/warm-spring-washington-county
- Source: Soaking Springs, researched and maintained by Armen Suny
- Updated: 2026-09-14

## Can you soak at Warm Spring?

The water leaves the ground at 75°F, about as warm as a heated pool. You can drive right up to it. We haven't confirmed whether it has a pool or charges a fee.

## Key facts

| Fact | Value |
|---|---|
| Source water temperature | 75°F (24°C) (USGS record; developed pools are often cooled) |
| pH | 8.0 (Slightly Alkaline) |
| Total dissolved solids | 341 mg/L |
| Elevation | 2,820 ft |
| Access | Roadside, 3 ft from the nearest road |
| County | Washington County |
| Nearest town | Washington |
| Coordinates | 37.13700, -113.51300 |
| Best months to soak | December, January, February (largest gap between water and average air temperature) |
| Nearest campground | Red Cliffs Campground, 8.4 mi |

## About Warm Spring

Warm Spring, the Washington County one, rises right beside a road on the outskirts of the town of Washington, a mile and a half out. The water is tepid. Unusually for this part of the record, the chemistry was sampled in 2004, so the figures on the page are recent enough to trust. The USGS lists it and there is a photo on file. Owner and access are blank.

The spring is roadside in the plainest sense, a few feet from an unnamed road. This is the low desert corner of Utah, under three thousand feet, where snow hardly ever falls and the year sees about eight inches of precipitation. Nothing in the record identifies the land owner or any managing unit.

December through February is the listed window, which here means mild winter days. Red Cliffs Campground is about eight miles away. The 2004 sample gives modest minerals and a slightly alkaline pH. Since access is not recorded and the spring is this close to town, find out whose ground it is before stopping.

## Water chemistry

Lab sample from 2004-05-04 (Water Quality Portal).

| Measure | Value |
|---|---|
| pH | 8 |
| Total dissolved solids | 341 mg/L |
| Calcium | 66.7 mg/L |
| Magnesium | 22.3 mg/L |
| Sodium | 10 mg/L |
| Sulfate | 112 mg/L |
| Chloride | 8.46 mg/L |

## Nearby

- Nearest city page: [Hot springs near Washington](https://www.soakingsprings.com/hot-springs/near/utah/washington-washington), 1 mi away
- State page: [Hot springs in Utah](https://www.soakingsprings.com/hot-springs/utah)
- [Green Spring, UT](https://www.soakingsprings.com/hot-springs/utah/green-spring): 75°F source, pH 7.3, TDS 1,490 mg/L, Roadside, near Washington, Washington County
- [Warner Valley Spring, UT](https://www.soakingsprings.com/hot-springs/utah/warner-valley-spring): 70°F source, pH 7.3, TDS 1,680 mg/L, Roadside, near Washington, Washington County
- [Virgin River Spring, UT](https://www.soakingsprings.com/hot-springs/utah/virgin-river-spring): 70°F source, TDS 988 mg/L, Short Walk, near Hurricane, Washington County
- [Snow Spring, UT](https://www.soakingsprings.com/hot-springs/utah/snow-spring): 70°F source, pH 7.8, TDS 226 mg/L, Short Walk, near Ivins, Washington County
- [Berry Springs, UT](https://www.soakingsprings.com/hot-springs/utah/berry-springs): 75°F source, pH 7.3, TDS 1,360 mg/L, Roadside, near Hurricane, Washington County
- [Dixie (Laverkin) Hot Springs, UT](https://www.soakingsprings.com/hot-springs/utah/dixie-laverkin-hot-springs): 108°F source, TDS 8,890 mg/L, Roadside, near LaVerkin, Washington County

## Questions

**What is the water temperature at Warm Spring?**
Warm Spring has a water temperature of 75°F (24°C). This is a warm thermal spring.

**Where is Warm Spring located?**
Warm Spring is located in Washington County, Utah at 2,820 feet elevation, near Washington. Coordinates: 37.1370°N, 113.5130°W.

**How do I get to Warm Spring?**
Warm Spring has Roadside road access (3 ft from the road).

**Can I camp near Warm Spring?**
Yes, Red Cliffs Campground is located nearby (8.4 miles away).

**What minerals are in the water at Warm Spring?**
Water chemistry analysis shows the presence of pH, Total Dissolved Solids, Calcium, Magnesium, Sodium, Sulfate, Chloride. The pH is 8.0 (slightly alkaline). Total dissolved solids measure 341 mg/L.

## Sources

- USGS thermal springs records, Water Quality Portal lab analyses, OpenStreetMap, Wikipedia/Wikidata, NOAA climate normals
- https://en.wikipedia.org/wiki/Hot_spring
